To obtain your registration ID "Invitation Code", please send your request to: autoprofessionals@mail.ru


ITCDiag
OBD2 Buy, OBD2, OBDII, OBD, car diagnostic, truck scanner, workshop, Chip tuning, fault code reader, IMMO
obdresource
xcar360

DiagPro3

 
Donate and Help Forum

After DONATION send EMAIL to ADMINSTRATOR HERE.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help to check key status of
#1
Dear all here,
Kindly check my dumps and key data attached in post same car dump move second hand ecu and immo 89661-0DE20 & 89780-0D030 car not start on key if immo disconnect car 2sec then go off get Dtc B2795 unmatched key code kindly help Thanks in Advance


Best Regards

Paul


Attached Files
MI.rar
File Type: .rar
Downloaded: 28 times
Size: 1.02 MB

Reply
Thanks given by:
#2
Toyota 
Hello Brother, your file key prog.
write dump in immo only immo
ecu not change file
then has to make a bridge between pin 4 and 13 OBD2, then you can see in the instrument panel light check engine starts flashing. esprar now only 30 minutes, then remove the bridge OBD2 connector and start the engine.
good luck


Attached Files
Mi Etios 93C66 key prog OK.rar
File Type: .rar
Downloaded: 9 times
Size: 214 bytes

Reply
Thanks given by: iman


Forum Jump:


Users browsing this thread: 1 Guest(s)