Latest news: --- 16D920875 .sgo --- autocom delphi 2015r3 whith key --- AK500+SKC WMVARE FULL --- MANTIS 2017 --- peugeot 306 hdi EDC15C2 --- AUTOCOM 2015.1 hex2stuff VM VERSION --- nissan navara dpf off --- Hurd cut rev limiter pop corn opel astra gtc 1.9 150 cv bosch edc16c9 --- Need MB EIS W211 ST12 Flash dump --- MB EIS W211 ST12 Flash Dump Needed --- Need help installing Xentry XDOS 03/2017 --- Ford VCM I / IDS Problem --- Opel Combo radio code --- FULL CFF DATABASE of MB VGS/NAG/EGS (5/7/9 G-Tronic) PWK/TRANSP --- Continue to use ETKA 7.5 and updates .... --- vectra c b1000 dtc --- SUZUKI SDT-II_2150057(04_2017) --- spanish_estimate4.2017 --- AUTOCOM 2015.1 VM VERSION --- Odis 4.0.0 11/04/2017 SETUP AND POSTSETUP ---
  
To Obtain Your Registration "CODE"AP Forum, Please Send A Request To: autoprofessionals@mail.ru

@@@Cheap Remote Support Service@@@ Perfect Quality and Latest Products !!!

http://www.autoprofessionals.org/showthread.php?tid=5742


 
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
JLR SDD v131
#1
Hi,

I need too make two things in my Jaguar S-Type 2.7:

- Programming the injectors
- Calibration of the steering angle sensor

I just found the vmware with v131 of the JLR SDD on net but I don't find where to make this programming. For what I read, I think I need to enter a PIN based on a VIN in the key that shows on the main screen. Is that right?

Where I found that PIN if so?

Thanks
Reply
Thanks given by:
#2
No not right, to program injectors click on service functions then recomendations at top of screen will then bring up a list, scroll down, you will see two actions for injectors suggest you read injector codes stored first take photo of results so that you can go back if need be, then you can use the other action to calibrate, if differant injectors are being fitted you will need the codes to input
Reply
Thanks given by: SC0TT


Forum Jump:


Users browsing this thread: 1 Guest(s)