Scania coordinator calibration

[rGtooR]

Hello I have bought a new coordinator for my truck ems6 how we can calibration the coordinator?
Any help ? I know my pin code

[rafik]

Hello I have bought a new coordinator for my truck ems6 how we can calibration the coordinator?
Any help ? I know my pin code

hi
Perform spare parts programming in SDP3, you must unlock the Coo, and then lock, enter the PIN code and encryption code, and the SDP3 version must be new

[popeo]

before disassembling the old COO you have to unlock it with sdp3 it will ask you for the code enter it when you get the message of successful release turn off the panel disconnect the old COO and install the new one.
start sdp3 open the connection with the pc and start checks and recordings, recognize the new COO give ok for the new spare
finish the configuration and go to user functions

anti-theft protection
calibration and finally you make the adaptation with the engine control unit, you will have to enter the codes and if everything is successful you will have the two adapted control units and the unlocking of the fuel valve

[Raidraid]

Hello all

SCANIA Immobilizer off Removal/Disable

unlock EMS with COO
Manual method neglects the key switch ON of time is 12 hours

1-You need a program (SDP3)
2-You need a program (XCOM)
3-You need a program (SOPS)
4-You need a program (XML Editor)
5-You need a PDF (SCANIA Parameters)

A = Enable
Z = Disable

2344 Immobilizer..............A With
2344 Immobilizer..............Z Without